zNET Fixed-base Wireless Quickstart for Windows 95 and 98

To connect one computer:

1. Ensure you have a Ethernet Network Interface Card (NIC) installed and correctly configured in your computer.

2. Plug one end of a CAT 5 cable into your computer's NIC and the other end into the LAN interface on the Wireless Internet transceiver.

3. Open the property settings for your computer's LAN interface by doing the following:
   • Right-click on Network Neighborhood and select Properties

   

4. Click TCP/IP then click the properties button, then click on the IP Address tab. Enter your computer's IP address and subnet mask (included in your install package).

   

5. Click the Gateway tab and specify the gateway address (included in your install package)

   

6. Click the DNS tab and specify your DNS server primary and secondary addresses.
   • Primary: 207.167.67.1
   • Secondary: 207.167.96.1

7. Click OK until prompted to restart. You must restart your computer for the new settings to take effect.

8. Finished.

To connect multiple computers:

1. You will need to connect an Ethernet hub or switch into the Wireless Internet transceiver. Follow the instructions included with your hub or switch for connecting to a router. In some instances, a cross-over Ethernet cable may be required. However, some devices have built-in cross-over ports than can be used in lieu of cross-over cables.

2. Follow the steps for connecting one computer above, skipping step 2. Plug one end of your computer into an available port on the hub or switch.

3. Continue the instructions above, beginning at step 3.