zNET Multilink (Dual Modem)
Quickstart for Windows XP
Note: Multilink connections require a Multilink enabled account
to work. To upgrade your account to Multilink, just email Customer Care or phone
800-438-9638.
First, setup your internet connection as per the instructions here. Make sure both modems are
attached to your computer and hooked up to a separate phone line each.
Click on Start button, and choose "Connect To"
Right click on your zNET
connection
Click on Properties
Cick on the General tab
Check the boxes next to the modems you wish to use
Check the box next to "All devices dial the same
phone number"
Click on the Options tab:
In the "Multiple Devices" box, choose "Dial all devices"
(Windows XP can be configured to use additional devices only when
traffic is heavy. You can configure this by choosing "Dial devices only
as needed" instead and then clicking the Configure button).
Click on the Networking tab
Click on the Settings tab
"Enable LCP Extensions" should NOT be checked
"Enable Software Compression" should be checked
"Negotiate multi-link for single-link connection"
should be checked
Click "OK" and "OK" again to close out of dialog boxes.
